Ud Client integrates into the mainline User Data
Repository product release stream and is available with UDR product by default.
There are no specific dependencies on Policy Management behavior, so this
feature is compatible with any Policy Management product release that is
supported in combination with the release that contains this feature.
To
enable and configure Ud Client feature:
-
Install and
configure User Data Repository.
-
To activate the Ud
Client feature, select
Ud Client
Options from the main menu, and then select the
Ud Client
Enabled checkbox.
-
Configure
Ud Client
Options. See
Enabling Ud Client Options.
-
Configure LDAP/SOAP
connection details to the Ud Server. See
Configuring Ud Remote Server.
-
Configure the LDAP
attribute to UDR subscriber Profile key field mappings. See
Modifying Ud Client Key Details.
-
Configure the LDAP
attribute to UDR subscriber Profile non-key field mappings. See
Configuring Ud Client Attribute Map SEC.
-
Check the Ud Client
Connection Status to ensure that LDAP and SOAP (if SOAP is configured)
connections are enabled and connected.
-
If the Admin State
for the LDAP and/or SOAP connections is disabled, then select the header row of
the connection type and click Enable.
The Ud
Client is now enabled and configured. If connections do not go into the
InService status, check alarms. Ud Client measurements and the Event History
for further information if the connections are not established.