Adding an Auto Enrollment Blacklist

Use this procedure to configure an auto enrollment blacklist, which is used to deactivate auto-enrollment on a range of subscribers. A blacklist is checked before auto enrollment can be triggered from either the Provisioning interface or the Sh interface.

You can only perform this task when logged into the Active Primary NOAMP. Note that you must have permission to edit this page. Permission groups are defined on the Main Menu > Administration > Access Control > Groups page.

1. Select UDR > Configuration > Auto Enrollment > Auto Enrollment Blacklist.
   The Auto Enrollment Blacklist page appears.
2. Click Insert. (Note that you must have permission to add a blacklist record on this page for the Insert link to be active.)
   The Auto Enrollment Blacklist [Insert] page appears. For a detailed explanation about the options and valid input for the fields on this page, see Auto Enrollment Blacklist Elements.
3. Select the type of key in the Key Type field to be associated with this blacklist.
4. Enter the Start Range and End Range values for the subscriber ID range to be blacklisted.
5. Perform one of the following:
   • Click OK to save the blacklist and return to the Auto Enrollment Blacklist page.
   • Click Cancel to return to the Auto Enrollment Blacklist page without saving the changes.
   If OK is clicked and any of the following exist, an error message appears:

   • Any required field is empty; no value was entered or selected (All fields on this page are required.)
   • The entry in any field is not valid (wrong data type or out of the valid range)
   • The Blacklist ID is not unique; it already exists in the auto enrollment blacklist list