Adding a Subscribing Client Permission

Use this procedure to define a client host and its permissions.

You can only perform this task when logged into the Active Primary NOAMP.

1. Select UDR > Configuration > Subscribing Client Permissions.
   The Subscribing Client Permissions page appears.
2. Click Insert.
   The Subscribing Client Permissions [Insert] page appears.
3. Enter an existing client host name in the Client Host field.
4. Click to check mark the permissions to associate with this client host - UDR, PUR, and/or SNR.
5. Perform one of the following:
   • Click OK to save the permissions and return to the Subscribing Client Permissions page.
   • Click Cancel to return to the Subscribing Client Permissions page without saving the changes.
   If OK is clicked and any of the following exist, an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field is not valid (wrong data type or out of the valid range)
   • The client host is not unique; it already exists in the subscribing client permissions list