Configuration Sequence

The following configuration steps are required before using the UDR system for the first time.

Configure your system in the following order; perform the steps from the primary active NOAMP unless otherwise noted:

1. Configure the first NOAMP using

   Configuration > Network Elements;

   Configuration > Services; and

   Configuration > Servers.

2. Configure remaining servers using

   Configuration > Network Elements; and

   Configuration > Servers.

3. Configure XSI networks (All SOAM sites) using

   Configuration > Network.

4. Pair primary NOAMP servers (for first NOAMP site only) using

   Configuration > Server Groups;

   Status & Manage > HA; Status & Manage > Server;

   Alarms & Events > View Active; and

   Administration > SNMP.

5. Pair SOAM and DR sites using

   Configuration > Server Groups;

   Status & Manage > HA; and

   Status & Manage > Server.

6. Configure MP server groups using

   Configuration > Server Groups; and

   Status & Manage > Server.

7. Configure MP signaling interfaces using

   Configuration > Network > Devices; and

   Configuration > Network > Routes.

8. Configure ESPR application on MP (all SOAM sites) (from SOAM) using

   Diameter > Configuration > DA-MPs > Profile Assignments;

   Diameter > Maintenance> Applications; and

   (from active NOAMP VIP)

   Communication Agent > Maintenance > HA Services Status.

9. Configure local nodes (all SOAM sites) using

   Diameter > Configuration > CEX Parameters;

   Diameter > Configuration > Configuration Sets > CEX Configuration Sets; and

   Diameter > Configuration > Local Nodes.

   • Add IP addresses for all of the MPs in the same server group as the SOAM.
10. Configure peer nodes (all SOAM sites) using
    Diameter > Configuration > Peer Nodes.

    • Create a Peer Node for each of the PCRF's MPEs.
11. Configure MPE to MP connections (all SOAM sites) using
    Diameter > Configuration > Connections.

    • For each MP, create connections to all desired MPEs
12. Add permissions for the FQDN of the peer node (primary NOAMP site) using
    UDR> Configuration > Subscribing Client Permissions.

    • For each peer node's FQDN value, create an entry on Subscribing Client Permissions page
13. Configure allowable remote connections (primary NOAMP site) using

    UDR > Configuration > Provisioning Connections.

The UDR installation provides a default configuration, so no additional configuration steps are required. Additional configuration actions may be taken to customize the system.