RFC 2833 SA Configuration

To configure session agents:

1. In Superuser mode, type configure terminal and press Enter.

   ORACLE# configure terminal

2. Type session-router and press Enter to access the system-level configuration elements.

   ORACLE(configure)# session-router

3. Type session-agent and press Enter. The system prompt changes to let you know that you can begin configuring individual parameters.

   ORACLE(session-router)# session-agent
   ORACLE(session-agent)#

4. rfc2833-mode—Set the RFC 2833 mode you want the session agent to use. The default is none. The valid values are:

   • none—2833 to UII interworking is based on the H.323 stack configuration.

   • transparent:—The 2833 or UII negotiation is transparent to the Oracle® Enterprise Session Border Controller. This overrides the H.323 stack configuration, even if the stack is configured for preferred mode.

   • preferred:—2833 for DTMF transfer is preferred, which is signaled in the TCS. If the endpoint supports 2833, 2833 is used. If not, the H.323 stack configured as preferred will revert back to using UII. This overrides any configuration in the h323-stack even if the stack is configured for transparent mode.

5. rfc2833-payload—Enter a number that indicates the payload type the session agent will use for RFC 2833 packets while interworking 2833 and UII. The default value is 0. The valid range is:

   • Minimum—0, 96

   • Maximum—127