RTC Support
This appendix summarizes real-time configuration (RTC) support status for the Oracle® Enterprise Session Border Controller . The table below lists which configuration elements are supported by RTC and which are not.
ACLI Configuration Elements | Parameter Details |
---|---|
Access Control | |
Accounting Config | |
Authentication | |
Certificate Record | |
Class Profile | |
Codec Policy | |
DNS ALG Service | |
DNS Config | |
Enum | |
External Policy Server | |
H.323 |
The following H.323 stack subelement parameters are not RTC supported in that, if you save and activate a configuration, calls already in progress will be dropped. A reboot is required.
|
Host Route | |
IPSEC | |
IWF | |
Licensing | |
Local Policy | |
Local Response Map | |
Local Routing Config | |
Media Manager |
The Media Manager element is supported with the exception of the following parameters:
|
Media Policy | |
Media Profile | |
Network Interface | |
Net Management Control | |
Network Parameters |
The Network Parameters element is supported with the exception of the following parameters:
|
NTP Sync | |
Packet Trace Config | |
Q850 SIP Map | |
Realm Config | |
Redundancy Config |
The Redundancy Config element is supported with the exception of the following parameters:
|
Session Agent | |
Session Group | |
Session Router | |
Session Constraints | |
Session Translation | |
SIP Config |
The SIP Config element is supported with the exception of the following parameters:
|
SIP Feature | |
SIP Interface | collect>boot-state |
SIP Manipulation | |
SIP NAT |
The SIP NAT element is supported with the exception of the following parameters:
|
SIP Response Map | |
SNMP | |
Static Flow | |
Steering Pool | |
Surrogate Agent | |
System |
The System Config element is supported with the exception of the following parameters:
|
Test Pattern Rule | |
Test Policy | |
Test Translation | |
TLS Global | When configured to support MSRP over TLS, this configuration element is not RTC enabled. If a single TLS profile is used by both SIP and MSRP, RTC changes will be applied for the SIP TLS configuration ONLY. |
TLS Profile | |
Translation Rules | |
Trap Receiver | |