Public Settings on the Net-Net ESD

To set a public setting on the Net-Net ESD:

1. Type http-alg-public and press Enter.

   ACMEPACKET(http-alg)# http-alg-public
   ACMEPACKET(http-alg-public)#

   The public side (outside the network) is used to receive incoming HTTP SOAP Requests from the remote worker. You define the IP address, port, and TLS certificate used to establish a connection with the remote worker by setting this http-alg-public attribute.

2. realm-id—Name of the realm that the Net-Net ESD uses to listen for the HTTP request. Valid values are alpha-numeric characters. Default is blank.
3. address—IPv4 or IPv6 IP address on which the Net-Net ESD is listening for HTTP traffic. Valid values must be in the format of 0.0.0.0. Default is blank.
4. port—Port on which the Net-Net ESD is listening for HTTP traffic. Valid values are 1 to 65535. Default is 80.
5. tls-profile—The TLS profile used to establish a secure connection with the remote worker. Setting this attribute enables HTTP proxy to listen for HTTPS traffic. Valid values are alpha-numeric characters. Default is blank.
6. Type done and press Enter.

   ACMEPACKET(http-alg-public)# done
   ACMEPACKET(http-alg-public)#

7. Type exit and press Enter.

   ACMEPACKET(http-alg-public)# exit
   ACMEPACKET(http-alg)#

8. Type exit and press Enter.

   ACMEPACKET(http-alg)# exit
   ACMEPACKET(session-router)#

9. Save the configuration.