H.232 Interfaces Configuration

These are the ACLI parameters that you set:

name                  Name of the stack
state                 State of the stack
isgateway             Enable the stack to run as a gateway
terminal-alias        List of aliases for terminal
ras-port              Listening port for RAS request
gk-identifier         Gatekeeper's identifier
q931-port             Q.931 call signalling port
alternate-transport   Alternate transport addresses/ports
q931-max-calls        Maximum number of Q.931 calls
max-calls             Stack's maximum number of calls
max-channels          Maximum number of channels per channel

To access the H.323 interface (h323-stack) and service mode parameters:

1. In Superuser mode, type configure terminal and press Enter.

   ORACLE# configure terminal

2. Type session-router and press Enter to access the media-related configurations.

   ORACLE(configure)# session-router

3. Type h323 and press Enter.

   ORACLE(session-router)# h323

4. Type h323-stacks and press Enter.

   ORACLE(h323)# h323-stacks
   ORACLE(h323-stacks)#

   From this point, you can configure H.323 interface and service mode parameters. To view all H.323 interface parameters, enter a ? at the system prompt. The display also includes H.323 service mode parameters.