Cash Drawer 1 and 2 Connectors

All MICROS Workstations contain a pair of the connectors shown in the figure below.

Figure 33-5 MICROS 4-Pin DIN Cash Drawer Connectors

The Series 2 Cash Drawer connector is an 8-pin Mini-IDN. This pair of Cash Drawer connectors is used by the Workstation 6 and the Base Station.

Figure 33-6 8-Pin Mini-DIN (Series 2) Cash Drawer Connector

The following table describes the signal name and function of each pin:

Table 33-1 Series 2 Cash Drawer Pin and Signal Reference

Pin #	Signal name	Description
1	VCC12 or VCC24	Cash Drawer power
2	CD_OPEN	Open drawer
3,7,8	Ground	Signal grounds
4	CD_ST	Input status from cash drawer
5	MCU_TX_5V	Tx data to Cash Drawer
6	MCURX	Rx data from Cash Drawer