Go to primary content
Diameter Signaling Router Full Address Based Resolution (FABR) User's Guide
Release 8.2
E89003-01
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

Deleting a Diameter application from the list of supported Diameter applications

Use this task to delete a Diameter application from the list of supported Diameter applications.

An application cannot be deleted if it is being used by an Address Resolution. Before you perform this task, delete any Address Resolution that uses the Application.

  1. Select FABR > Configuration > Applications.
  2. Select the application you want to delete and click Delete.

    Note:

    An error message appears if the application has already been removed.
  3. Click OK or Cancel on the confirmation screen.