Associating a Rule Set with a Trigger

Use this procedure to associate a Rule Set with a Trigger.

Only Rule Sets with Rule Templates in Test or Active state can be associated with a Trigger.

The fields are described in Table 3-24

1. Click Diameter > Mediation > Triggers.
2. The newly assigned Rule Set appears at the bottom of the list of Rule Sets for the Trigger. If the Rule Set sequence needs to be changed, use the Up and Down buttons to move the Rule Sets to different positions in the list.
   Click a Rule Set and the Up and Down buttons to move the selected Rule Set up or down one position on the list.

   The Live column shows a check mark if the Rule Template for the newly associated Rule Set is in the Active state for use with live traffic (see State and Properties).

3. Click Insert under the Trigger with which the new Rule Set is to be associated.
   The Diameter > Mediation > Triggers [Insert] page does not open and an error message appears if any of the following conditions exist:

   • There are no Rule Sets that support the Trigger and that are in the Active or Test state
   • Associating another Rule Set to the Trigger would cause the total allowed number of associated Test Rule Sets (10) or Active Rule Sets (64) to be exceeded
4. Select the Rule Set Name from the list.
   The default is the first Rule Set in the list.
5. Select the Request type from the list.
6. Select the Scope of the Rule Set.
7. Click OK or Apply