Identifying the Diameter network and properties for Policy DRA

1. Identify and log the hardware profile type for each of the DA-MP Servers (PCA).
2. Identify and log the number of policy clients (PCEFs, BBERFs and AFs) and policy servers (PCRFs) in the network.
3. Identify and log the Diameter attributes for all the policy clients and policy servers in the network - FQDN, Realm, IP address.
4. Identify and log the type of Diameter Transport Protocol needed for all the policy clients and policy Servers - TCP/SCTP.
5. Identify and log the type of Diameter connection mode needed for all the policy clients and policy server - Responder/Initiator/Responder-Initiator.
6. Identify and log the Peer Node Identification for all the policy clients and policy servers - IP Address/FQDN.
7. Identify and log the route groups and route lists needed for Policy Servers and Policy Clients. Routing configuration is required for Policy Clients if the Policy Servers send Diameter request messages to be routed to the Policy Clients.
8. Identify and log the Policy Server configuration needed - both that Gx and Rx are on same Policy Server or that they are on different servers.
9. Identify and log the number of peer route tables needed for the Diameter configuration such as one for Rx Policy Servers and one for Gx Policy Servers.
10. Identify and log the number of Application Route Table entries - one for Gx Application and one for Rx Application message processing.
11. Identify and log the TSA used for local nodes if IPFE is used.