Go to primary content
Diameter Signaling Router Range Based Address Resolution (RBAR) User's Guide
Release 8.2
E89002-01
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

Inserting an Address Table

Use this task to add a new Address Table.

  1. Click RBAR > Configuration > Address Table.
  2. Click Insert.
  3. Enter a unique name for the Address Table in the Name field.
    For more information about each field, see Table 4-4.
  4. If needed, enter a comment or additional information about the Address Table in the Comment field.
  5. Select the type of routing entity from the Routing Entity Type list.
  6. If External Identifier was selected as the Routing Entity Type, then select the Routing Entity Component from the list.
  7. Click OK, Apply, Cancel.
    If OK or Apply is clicked and any of the following conditions exist, an error message appears:
    • Any required field is empty; no value was entered or selected
    • The Name is not unique; it already exists in the system
    • The entry in any field is not valid (wrong data type or out of the valid range)
    • The maximum number of Address Tables (40) is already defined in the system