Go to primary content
Diameter Signaling Router Range Based Address Resolution (RBAR) User's Guide
Release 8.2
E89002-01
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

Editing an Address

Use this task to edit an address associated with a Routing Entity type.

  1. Click RBAR > Configuration > Addresses.
  2. Select the Address you want to edit and click Edit.
  3. Update the relevant fields.
    For more information about each field, see Table 4-5.
    The following fields are read-only and cannot be edited:
    • Routing Entity Type
    • Routing Entity Component
    • Address Type
  4. Click OK, Apply, or Cancel.
    If OK or Apply is clicked and any of the following conditions exist, an error message appears:
    • Start Address is greater than the End Address
    • Start Address and End Address for an Address Range are overlapping or already exists
    • Address already exists for a Table Name
    • The entry in any field is not valid (wrong data type or out of the valid range)
    • Any required field is empty