Inserting a Destination

Use this task to add a new Destination.

1. Click RBAR > Configuration > Destinations.
2. Click Insert.
3. Enter a unique name for the destination in the Name field.
   For more information about each field, see Table 4-3.
4. Enter the realm in the Realm field.
5. Enter a unique FQDN in the Fully Qualified Domain Name field.
6. If you want to allow subsequent invocation of RBAR on a different DSR node in the network, leave the Allow Subsequent RBAR invocation check box selected (by default, this option is checked).

   Note:

   If you do not want to allow subsequent invocation of RBAR on a different DSR node in the network when RBAR resolves to this destination, uncheck this check box. In addition, the Allow Subsequent RBAR invocation check box on the System Options page must be unchecked. For more information about the System Options attributes, see Table 4-7.
7. Click OK, Apply, or Cancel.
   If OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • Both the Realm and Fully Qualified Domain Name are empty; no value was entered
   • The Name or Fully Qualified Domain Name is not unique; it already exists in the system
   • The entry in any field is not valid (wrong data type or out of the valid range)
   • The required Name is empty
   • The maximum number of destinations (1024) is already defined in the system