Adding routing entities

You can only perform this task when logged into the Active Primary SDS.

Before performing this task, make sure Destinations and NAI Hosts have been configured.

1. Select SDS > Configuration > Routing Entities.
2. Click Insert.
3. Select the type of routing entity from the Type list.
4. Enter the route identifier for the routing entity in the Address or Address Prefix field.

   Note:

   The Address field requirements depend on the type of blacklist routing entity. For more information on this field, see Blacklist configuration elements.
5. If NAI User or Wildcard NAI User is selected as the Type, select a NAI host from the NAI Host list.
6. If External Identifier is selected as the Type, enter a Local Identifier and select a Domain Identifier.
7. Select the associated destination(s) from the applicable destination(s) list.
   At least one destination must be selected, although a destination can be selected for each of the destination types.
8. Perform one of the following:
   • Click OK to save the Routing Entity and return to the SDS Routing Entities page.
   • Click Apply to save the Routing Entity and remain on this page.
   • Click Cancel to return to the SDS Configuration Routing Entities page without saving the changes.
   If OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • Either MSISDN or IMSI was selected as the Type and a non-digit character was entered.
   • At least one destination was not selected.
   • Field Address or Local Identifier contains invalid characters.