Adding blacklist values

Follow these steps to add a single MSISDN or IMSI Blacklist value. These are values that will not be routed to a destination.

1. Select SDS > Configuration > Blacklist.
2. Click Insert.
3. Select the type of blacklist routing entity from the Type list.
4. Enter the blacklist route identifier for the routing entity in the Address field.

   Note:

   The Address field requirements depend on the type of blacklist routing entity. For more information on this field, see Blacklist configuration elements.

   Note:

   .
5. Perform one of the following:
   • Click OK to save the Blacklist and return to the SDS Configuration Blacklist page.
   • Click Apply to save the Blacklist and remain on this page.
   • Click Cancel to return to the SDS Configuration Blacklist page without saving the changes.
   If field validations succeed, the blacklist value is saved. If OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • If a non-digit character was entered.
   • The value entered for the MSISSDN or IMSI value already exists in the routing entities table.