Go to primary content
Diameter Signaling Router Subscriber Database Server User's Guide
Release 8.2
E89028
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

Adding destinations

You can only perform this task when logged into the Active Primary SDS.

  1. Select SDS > Configuration > Destinations.
  2. Click Insert.
  3. Enter a unique name in the Name field.
  4. Select the type of destination from the Type list.
  5. Enter a fully-qualified domain name (FQDN) in the FQDN field.
  6. Enter the realm in the Realm field.
  7. Perform one of the following:
    • Click OK to save the Destination and return to the SDS configuration connections page.
    • Click Apply to save the Destination and remain on this page.
    • Click Cancel to return to the SDS Configuration Destinations page without saving the changes.
    If OK or Apply is clicked and any of the following conditions exist, an error message appears:
    • Any required field is empty; no value was entered or selected
    • The entry in any field is not valid (wrong data type or out of the valid range)