Editing a Transport

Use this procedure to change fields for a configured Transport.

Fields that are not grayed-out can be edited.

Fields that are grayed-out cannot be edited.

The fields are described in Transport Configuration elements.

When the Transport Manager > Configuration > Transport [Edit] page opens, the fields are populated with the current configured values.

Note:

A Transport cannot be edited unless it is in the Disabled Administrative State. To disable the Transport, see Disabling a Transport

1. Select Transport Manager > Configuration > Transport.
2. Click Edit.
3. Make the desired changes. For field definitions, see Transport Configuration elements.
4. Perform one of the following actions:
   • Click OK to save the data and exit this page.
   • Click Apply to save the data and remain on this page.
   • Click Cancel to exit this page without saving any changes.
   When OK or Apply is clicked and any or the following conditions exist, an error message appears:

   • Any field contains a value that is not valid or is out of the allowed range.
   • Any required field is empty (not entered).
   • A value that must be unique is not unique.
   • IP Address 1 and IP Address 2 are the same address.
   • The value combination of IP Address 1 and port, or IP Address 2 and port, is not unique.
   • A selected value no longer exists (has been deleted).
   • The Transport Admin State could not be obtained from the MP server: Refer to the Status & Manage > Server GUI page for possible causes.

The edited Transport data is written to the database. The Transport remains in the Disabled Administrative State. To enable the Transport, see Enabling a Transport.