Re-ordering Load Shedding Rules

After creating a load shedding rule, you can be clone, modify or delete rules. In addition, you can re-order rules to meet different your needs.

Re-ordering load shedding rules puts a different priority on them, so if you need to shift priorities in your load shedding rules, use this procedure.

Complete these steps to change the order of load shedding rules.

From the MRA section of the navigation pane, select Configuration.
The content tree displays a list of MRA groups; the initial group is ALL.
From the content tree, select the MRA that needs load shedding capabilities.
The MRA Administration page opens.
From the MRA Administration page, select the MRA tab.
The current MRA configuration settings are displayed.
Click Advanced.
The Advanced MRA Settings page opens.
Click Modify.
Select the section (MRA Load Shedding Configuration or MPE Load Shedding Configuration) to change.
Select the rule to be re-ordered in the list.
Click the (up arrow) or (down arrow) on the toolbar to place the rule in the desired position in the list.