Configuring SigC in Devices Exposed to PCEF

The ability of an MRA sever to use SigC in VLAN 3 enables that MRA server to utilize internal signaling communication between an MPE server and itself. SigC configuration is used when the hardware selected for the MRA server is either C-Class, C-Class (Segregated Traffic), NETRA, or VMWare.

Note: To configure a device for SigC, the MRA server topology must be configured for either C-Class, C-Class (Segregated Traffic), NETRA, or VMWare. See Setting Up a Non-CMP Cluster

To configure SigC for use in VLAN 3:

  1. From the MRA section of the navigation pane, select Configuration.

    The content tree displays a list of MRA groups.

  2. From the content tree, select an MRA device.

    The MRA Administration page opens.

  3. From the MRA Administration page, select the MRA tab.

    The current MRA configuration settings are displayed.

  4. Click Advanced.
  5. Click Modify to edit the Service Overrides table.
  6. In the Service Overrides section, click Add.
  7. In the Add Configuration Key Value dialogue, enter the following information:
    1. Enter DIAMETERDRA.SIGDeviceFilter in the Configuration Key field.
    2. Enter SIGC in the Value field.
    3. (Optional) Enter information for this configuration in the Comments field.
  8. Click OK.
  9. Click Save.
You have configured the configured SigC for use in VLAN 3.
Parent topic: About Advanced Configuration Settings for the MRA