To add a subscriber quota category:
- From the SPR section of the navigation pane, select Profile Data.
The Subscriber Profile Administration page opens.
- Search for the subscriber profile you want to view.
- Select the Quota tab.
The Quota Usage information is shown in the work area.
- Click Create.
The Quota Usage page opens.
- If there are more than 10 quotas, a message displays prompting you to add more. Click Yes.
- Enter the following information:
- CID: A unique identifier assigned by the CMP system. Rollovers and top-ups have the CID of their associated plan.
Note: This information is assigned by the system, and you should not change it.
- Name (required): Select the name of a quota. You cannot add the same quota twice for a subscriber. See the Policy Wizard Reference for information on creating quotas.
- Type: Select the type of quota defined in the CMP system. You can select quota (plan), pass, rollover, top-up, or default rollover.
- Time (seconds): Enter a value, in seconds, to track time consumption.
The valid range is: -263 to 263– 1 (a 64-bit value).
- Total Volume (bytes): Enter a value, in bytes, to track bandwidth volume consumption.
The valid range is: -263 to 263– 1 (a 64-bit value).
- Upstream Volume (bytes): Enter a value, in bytes, to track upstream bandwidth volume consumption.
The valid range is: -263 to 263– 1 (a 64-bit value).
- Downstream Volume (bytes): Enter a value, in bytes, to track downstream bandwidth volume consumption.
The valid range is: -263 to 263– 1 (a 64-bit value).
- Service Specific Event: Enter a value representing service-specific resource consumption.
The valid range is: -263 to 263– 1 (a 64-bit value).
- Next Reset Time (required): Enter a date and time after which the quotas need to be reset, in the format yyyy-mm-ddThh:mm:ss[Z] (for example, 2011-11-01T00:00:01-5:00).
Alternatively, click
(calendar) and select a date, enter a time, and optionally select a UTC offset (time zone). Click
OK.
- Quota State: This field is an internal identifier and should not be defined by the user.
- RefInstanceID: The CID of the associated plan. This field only applies to a top-up type quota.
Note: This field is an internal identifier, and you should not change it.
- Click Save.
The subscriber quota is defined.