You can manually enable or disable all Sh connections for all MPE devices in a group. Operations are recorded in the audit log. An alarm is raised if either operation fails.
Note: If the enable or disable operation encounters an exception, the operation is not retried.
To manually disable or enable all Sh connections:
From the Policy Server section of the navigation pane, select Configuration.
The content tree displays a list of policy server groups; the initial group is ALL.
From the content tree, select the group that contains the servers.
The Policy Server Administration page opens in the work area.
From the Operations menu, select Enable Sh or Disable Sh.
The Bulk Enable Sh or Bulk Disable Sh dialog displays stating the number of servers affected.
Specify the delay time for applying the operation to each server. The number of seconds is 0 to 60. 0 is the default.
Click Enable Sh or Disable Sh to perform the action.
Sh connections for all of the MPE devices in the group are disabled or enabled.