To configure the network access server (NAS) network element:
- From the Network section of the navigation pane, select Network Elements.
The content tree displays a list of network element groups; the initial group is ALL.
- From the content tree, select a network element.
The Network Element Administration page opens in the work area.
- Select the NAS tab and then click Modify.
The Modify Network Element page opens.
- Configure the following information:
- Passphrase — Specifies the passphrase (RADIUS shared secret) for this network element.
Enter 1–255 characters. If the source IP address of a received message matches one of the IP addresses configured for the NAS device, then the
MPE device will attempt to decode the message using this default passphrase. If not specified, the default passphrase configured on the
MPE device (see
Managing Multimedia Policy Engine Devices) is used.
- IP Address — Specifies up to 20 IPv4/IPv6 addresses supported by this device.
To add an address to the list, enter it and click Add. To delete an address, select it from the list and click Delete.
- Click Save.
The NAS network element is configured.