Printer DIP Switch/Memory Switch Setting when using UB-IDN (IDN02) Interface

Table 37-5 TM-U200, TM-U220, TM-U2300

		DIP	SW	1						DIP	SW	2
1–1	1–2	1–3	1–4	1–5	1–6	1–7	1–8	2–1	2–2	2–3	2–4	2–5	2–6	2–7	2–8
x	x	OFF	OFF	OFF	OFF	OFF	x	ON*	x	x	x	x	x	x	x

Table 37-6 TM-T88 Series

		DIP	SW	1						DIP	SW	2
1–1	1–2	1–3	1–4	1–5	1–6	1–7	1–8	2–1	2–2	2–3	2–4	2–5	2–6	2–7	2–8
x	x	OFF	OFF	OFF	OFF	ON	OFF	x	x	x	x	x	x	x	x

Table 37-7 TM-T90, TM-L90 (Non-Peeler & Peeler)

		DIP	SW	2
1–1	1–2	1–3	1–4	1–5	1–6	1–7	1–8
x	ON	OFF	OFF	OFF	OFF	ON	OFF

Table 37-8 TM-T70

		DIP	SW	1						DIP	SW	2
1–1	1–2	1–3	1–4	1–5	1–6	1–7	1–8	2–1	2–2	2–3	2–4	2–5	2–6	2–7	2–8
x	x	OFF	OFF	OFF	OFF	ON	OFF	x	x	x	x	x	x	x	x

Table 37-9 TM-T70II

No DIP SW or Memory SW change is necessary.

Use GS (E command (Fn=11)) to set Serial Port Communication Parameters.

Table 37-10 Legend

OFF	ON	= Mandatory Setting
OFF*	ON*	= Recommended Setting
x		= Don’t Care