Special Configuration Settings

Caution: Do not change Special Configuration settings without guidance because incorrect or incompatible settings may cause the system to fail.

The Compact Workstation 310 ships with the BIOS pre-configured for optimal performance. In most cases you will not need to change settings.

To access the Special Configuration settings:

1. From the BIOS Home screen, tap Advanced, and then tap Special Configuration.

Table 8-2 Special Configuration Settings

Setting	Description of Option
USB Port 1	Enable or Disable USB port 1.
USB Port 2	Enable or Disable USB port 2.
USB Port 3	Enable or Disable USB port 3.
USB Port 4	Enable or Disable USB port 4.
USB Port 5 (High Power)	Select USB - 15V or USB - 5V for USB port 5.
422 Mode Selection	Enable or Disable RS-422 mode for the IDN port.
422/232 Mode Selection	Select 422 Mode or 232 Mode to enable RS-422 mode or RS-232 mode for the IDN port.
Power Failure Restoration	Select the action taken by the system in the event of a power failure: Remain Off: The system remains powered off even if it was originally powered on. Last State: If the system was on when power failed, the system powers on. If the system was off, the system remains off. Power On: The system powers on even if it was originally powered off.
Factory Recovery	Select factory recovery settings: Disable: You cannot perform factory recovery. Enable: You can perform factory recovery.
Casework Open Action	Select the action taken by the system if the workstation casework is compromised: Startup Warning: Presents a warning during startup if the system detects the workstation casework was compromised. Forced Off: Turns off the workstation if the system detects the casework was compromised.