RxRbarMsgRatePeak

Measurement ID

10304

Measurement Group

DSR Application Performance

Measurement Type

Max

Measurement Dimension

Single

Description

Peak DSR Application's Ingress Message Rate measured during the collection interval

Collection Interval

5 min

Peg Condition

When the maximum DSR Application Ingress Message Rate sample is taken during the collection interval

Measurement Scope

Server Group

Recovery

1. Display and monitor the DSR Application message rate by selecting Diameter > Maintenance > Applications. Verify that the message rate is set as expected.
2. Application Routing might be mis-configured and is sending too much traffic to the DSR Application. Verify the configuration by selecting Diameter > Configuration > Application Routing Rules.
3. There might be an insufficient number of MPs configured to handle the network load. Monitor the traffic rate of each MP by selecting Diameter > Status & Manage > KPIs.
   If MPs are in a congestion state, then the offered load to the server site is exceeding its capacity.
4. If the problem persists, it is recommended to contact My Oracle Support (MOS).