Go to primary content
Oracle® Communications Diameter Signaling Router Measurements
Release 8.3
E93201
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

RxPcaMsgRateAvg

Measurement ID
11361
Measurement Group
DSR Application Performance
Measurement Type
Average
Measurement Dimension
Single
Description
Average Policy and Charging DSR Application's Ingress Message Rate measured during the collection interval
Collection Interval
5 min
Peg Condition
When the average of all DSR Application Ingress Message Rate samples is taken during the collection interval.
Measurement Scope
Server Group

Recovery

  1. Display and monitor the DSR Application message rate by selecting Diameter > Maintenance > Applications. Verify that the message rate is set as expected.
  2. Application Routing might be mis-configured and is sending too much traffic to the DSR Application. Verify the configuration by selecting Diameter > Configuration > Application Routing Rules.
  3. There might be an insufficient number of MPs configured to handle the network load. Monitor the traffic rate of each MP by selecting Diameter > Status & Manage > KPIs.
    If MPs are in a congestion state, then the offered load to the server site is exceeding its capacity.
  4. If the problem persists, it is recommended to contact My Oracle Support (MOS).