EtlTmStaticThrottling

Measurement ID

14651

Measurement Group

Egress Throttle List Performance

Measurement Type

Simple

Measurement Dimension

Arrayed

Description

Duration of time (in seconds) that ETL throttling was being applied.

Collection Interval

5 min

Peg Condition

Note:

This measurement only applies when Limit Throttling mode is enabled and the ETG's control scope = ETL

A time duration interval is determined by:

• The time duration interval starts when:
  • The ETL's Operational Reason is changed to Static Rate Limit Exceeded
  • A new measurement collection interval begins and the ETL's Operational Reason is Static Rate Limit Exceeded
• The time duration interval stops when:
  • The ETL's Operational Reason is changed from Static Rate Limit Exceeded to any other value
  • The current measurement collection interval ends (such as the end of the current five minute collection interval)
  • When a time duration interval completes, the time measured is added to the total measurement value

Measurement Scope

Site

Recovery

1. None