Go to primary content
Oracle® Communications PMAC User's Guide
Release 6.6
E93272
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

Editing the enclosure OA IP addresses

  • Use this procedure to Change the active or standby OA's IP address.

Caution:

This command is not intended for general customer use and should be used only as directed by My Oracle Support.
  1. Log into the PMAC GUI as the guiadmin or pmacop user.
  2. Click Hardware > System Configuration > Configure Enclosures
  3. Click Edit Enclosure.
  4. Select an enclosure from the Enclosure ID list.
  5. Click Edit Selected Enclosure.
    The Edit Enclosure page shows the selected enclosure and the IP addresses of the associated OA(s).
  6. Perform one of the following actions:
    • Edit one or both of the IP addresses to inform PMAC of a change to the active or standby OA's IP address.
    • Add an IP address to add a standby OA to the enclosure configuration.
    • Delete an IP address to remove the connection between PMAC and an OA. Note that you cannot remove both OA IP addresses; at least one OA IP address is required.
  7. Click Submit
    This action launches the Add Enclosure background task. A message informs you that the background task has been launched. The message also provides a task ID and a link so that you can monitor the background task.
  8. Select the Task Monitoring link to monitor the background task.
    Click Refresh to update the data on the page.
  9. Monitor the task until it has completed.
    The progress status percentage indicator turns green when it has completed.
The enclosure is reloaded into the hardware inventory with the OA IP address changes. PMAC launches a rediscovery operation of the system configuration.