E4851 Cmd Rej: Removable media can not be inserted

For the act-upgrade command, when the action=convertstp parameter is specified, no removable media can be inserted in any of the USB ports.

Caution:

It is strongly recommended that this command be used only in conjunction with the system Upgrade Procedure for the target release. The Upgrade Procedure provides step-by-step information on performing an upgrade.

For the init-card command, if a removable drive is inserted in the system, then the prtngrp=inactive parameter cannot be specified.

Note:

When the init-card command is issued to the OAM software, there is a 10-second wait before the card is reset. This wait period is intended to ensure that all database updates are complete before the card is reset.

Recovery - act-upgrade

Remove the removable media and re-enter the command, specifying a valid combination of parameters.

Contact My Oracle Support for additional assistance. See My Oracle Support (MOS).

Recovery - init-card

Remove the MO from the card, re-enter the command that generated this error message, and load the drive. Refer to the command description in Commands User's Guide and to Database Administration - System Management User's Guide for assistance.

Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).