E4916 Cmd Rej: Command invalid for hardware configuration

For the act/dact-ip-lnk commands, the referenced card must be equipped and the value specified for the loc parameter must refer to one of the following cards:

• E5-ENET or E5-ENET-B card running the EROUTE, IPGWx, IPLIMx, IPSG, or STPLAN application
• IPSM card running the IPS application
• E5-SM4G or E5-SM8G-B card running the VSCCP application
• E5-OAM card running the OAMHC application
• E5-MCPM-B card
• SLIC card

For the chg-ee-card command, the card loc specified to detach a filter must have EE configured.

For the enable-ctrl-feat command, the EPAP Data Split or Dual ExAP Config feature can not be enabled if DSM, MPL, E1T1MIM, LIMATM, LIME1ATM cards are running in the system.

For the enable-ctrl-feat command, if the system is NOT in mixed mode (does not contain both OAM and E5-OAM cards) and is equipped with GPSM-II / TDM card(s), then the Integrated GLS and Integrated Measurements features cannot be enabled.

Recovery

1. Enter the rtrv-ctrl-feat command to retrieve the status of the EPAP Data Split or Dual ExAP Config feature in the system.
2. Install or remove the necessary cards. Refer to the Maintenance Guide for assistance.
3. Re-enter the command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).