E3084 Cmd Rej: Both OAM cards must be of the same type

The two cards that run the OAM must be the same type before the database can be updated.

Note:

Legacy TDM, GPSM-II, and MDAL cards cannot be installed in the same system as E5-TDM, E5-MCAP, and E5-MDAL cards.

For the chg-db command, if the OAM is in mixed mode, and the 10,000 Routesets or Integrated GLS feature is enabled or the Integrated Measurements feature is turned on, then the action=repair parameter cannot be specified.

If the OAM in mixed mode, and the 10,000 Routesets or Integrated GLS feature is enabled or the Integrated Measurements feature is turned on, then the copy-disk command cannot be entered.

Caution:

Contact My Oracle Support before entering the copy-disk command. See My Oracle Support (MOS).

Recovery

1. Display the cards in the database. Enter the rtrv-card command.
2. If necessary, determine whether the card is in mixed mode. Enter the rept-stat-card:appl=oam command.
3. If necessary, display the status of the controlled features in the database. Enter the rtrv-ctrl-feat command.
   If the feature does not appear in the output, then the feature is not enabled. If the feature has a status of OFF, then the feature is enabled but is not turned on.
4. Replace the cards as necessary. Refer to the Maintenance Guide for assistance.
5. Re-enter the command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).