E4918 Cmd Rej: Could not access USB disk

For the act-upgrade command, if the src=usb parameter is selected, then the plug-in flash drive upgrade media must be inserted in the Active OAM's flush-mounted USB port.

For the chg-db command, if the src=usb or dest=usb parameter is specified, then a plug-in flash drive must be inserted into the Active OAM's flush-mounted USB port.

For the chg-gpl command, a plug-in flash drive must be inserted in the Active OAM.

For the copy-gpl command, the plug-in flash drive must be accessible in the Active OAM's flush-mounted USB port.

Recovery

For the act-upgrade command, enter the rept-stat-db command to verify that a plug-in flash drive is installed. Install the drive if necessary. Refer to the Upgrade Procedures for the target release or Database Administration - System Management User's Guide for instructions.

Caution:

It is strongly recommended that the act-upgrade command be used only in conjunction with the system Upgrade Procedure for the target release. The Upgrade Procedure provides step-by-step information on performing an upgrade.

For all other commands, the usb value must be specified by Oracle personnel only.

Contact My Oracle Support if this error message appears. See My Oracle Support (MOS).