Oracle® Communications EAGLE Database Administration - GWS User's Guide Release 46.6 E93314 Revision 1 |
|
![]() Previous |
![]() Next |
Optional parameters of the enter linkset (ent-ls
) command or the change linkset (chg-ls
) command are used to set the screening state. These parameters are:
SCRN – the name of the gateway screening screen set that is associated with the linkset.
GWSA – Gateway screening action – The value on
allows gateway screening to be performed on the linkset. The value off
, does not allow gateway screening to be performed on the linkset. This parameter can only be specified if the scrn
parameter is specified.
GWSM – Gateway screening messaging – The value on
allows output messages to be generated. The value off
does not allow output messages to be generated. This parameter can only be specified if the scrn
parameter is specified.
GWSD – Gateway screening MSU discard – If gateway screening cannot be performed and the gwsd
parameter is set to on
, all MSUs on the linkset are discarded. These are two examples of why gateway screening could not be performed.
The value off
does not allow messages to be discarded. This parameter can only be specified if the scrn
and gwsa=on
parameters are specified.
Note:
Discarding all MSUs on a linkset will not allow any MSUs on the linkset to be routed. It is recommended that the value specified for thegwsd
parameter is off
. The gwsd
parameter should only set to on
if you wish screen MSUs for gateway screening rather than routing MSUs through the EAGLE. Refer to Commands User's Guide for more information on the ent-ls
or chg-ls
commands.