The following series of commands may be used to provision an IPSG-M2PA link on the same card, assuming the card, IP addresses and hosts are already configured.
- Enter an Application Server Process and bind an SCTP association with it (
ent-assoc
).
- Enter adjacent point code (
ent-dstn
).
- Define capacity and use alarm (
ent-ls
).
- Tell the EAGLE that this is a SIGTRAN M2PA link (
ent-slk
).
- Enter route (
ent-rte
).
- Allow and open the SCTP association (
chg-assoc
).
- Activate signaling link (
act-slk
).