T1 Interface Configuration Procedures

This appendix contains these procedures because they contain information specific to the T1 Interface:

• Adding a LIM-T1 Card
• Removing a LIM-T1 Card
• Adding Channelized and non-Channel Bridged T1 Ports
• Adding Channel Bridged T1 Ports
• Adding Unchannelized T1 Ports
• Removing the T1 Interface Parameters
• Changing the Attributes of a Channelized T1 Port
• Changing the Attributes of an Unchannelized E1 Port
• Making a Channel Bridged T1 Port from a Channelized T1 Port
• Making a Non-Channel Bridged T1 Port from a Channel Bridged T1 Port
• Adding a T1 Signaling Link

Procedures for configuring the linksets and routes, for removing SS7 signaling links (which includes T1 signaling links), and for configuring the HC MIM temperature alarms are contained in SS7 Configuration These procedures contain no information that is specific to the T1 interface, therefore, are not included in this appendix.

The procedures contained in this appendix use a variety of commands. If more information on these commands is needed, go to the Commands Manual to find the required information.