Realm-config Attribute

Use the following procedure to configure the realm-config attribute and enable session recording:

1. session-recording-server — Enter the name of the session-recording server or the session-recording-group in the realm associated with the session reporting client (Oracle® Enterprise Session Border Controller). Valid values are alpha-numeric characters. Default is no value specified.

   ACMEPACKET(realm-config)# session-recording-server <srs-name>
   
or

ACMEPACKET(realm-config)# session-recording-server SRG:<group-name>

   Note:

   The value for this attribute is the name you specified in the session-recording-server attribute. If specifying a session-recording-group, you must precede the group name with "SRG:".
2. session-recording-required — Enter whether you want a call to be accepted by the Oracle® Enterprise Session Border Controller when recording is not available. The default value is disabled.

   • Enabled — Restricts call sessions from being initiated when a recording server is not available.

   • Disabled (default) — Allows call sessions to initiate even when the recording server is not available.

     Note:

     Oracle recommends that the session-recording-required parameter remain disabled.
3. session-max-life-limit — Enter the maximum interval in seconds before the SBC must terminate long duration calls. The value supercedes the value of session-max-life-limit in the sip-interface and sip-config configuration elements and is itself superceded by the value of session-max-life-limit in the session-agent configuration element. The default value is 0 (off/ignored).

   test