E3009 Cmd Rej: LNP feature must be ON

The LNP feature (an LNP ported TNs quantity) must be enabled before the LNP 150,000 LRNs feature or the LNP 300,000 NPANXXs feature can be enabled.

The LNP feature must be turned on before the following actions can be performed:

• Change the LNP database
• Turn on the Wireless Number Portability (WNP) feature
• Retrieve or report on LNP information or measurements
• Enter the chg/rtrv-lnpopts, ent/chg/dlt/rtrv-acg-mic, ent/chg/dlt/rtrv-acg-noc, ent/chg/dlt/rtrv-lnp-serv, or rept-stat-lnp command
• Specify the appl=lnp parameter in the ent-ss-appl command
• Specify the data parameter in the rst-card command

• Change a system cpctype=lnp and the LNP subsystem.

Recovery

1. Display the status of the LNP feature. Enter the rtrv-ctrl-feat command.
   If the feature does not appear in the output, then the feature is not enabled. If the feature has a status of OFF, then the feature is enabled but is not turned on.
2. Enable and turn on the feature as necessary. Refer to Administration and LNP Feature Activation Guide and contact My Oracle Support before starting this process. See My Oracle Support (MOS).
3. If required, reset the terminal, terminal command class, and user ID privileges.
   Refer to Database Administration - System Management User's Guide for these procedures.
4. Re-enter the command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).