E2172 Cmd Rej: Command action is out of phase with expected procedure

For the act-upgrade command, the value specified for the action parameter must correspond to the upgrade phase of the system.

Caution:

It is strongly recommended that this command be used only in conjunction with the system Upgrade Procedure for the target release. The Upgrade Procedure provides step-by-step information on performing an upgrade.

For the act-flash command, the card must be running an inactive GPL.

For the init-flash command the card cannot be running an inactive flash GPL.

Recovery - act-upgrade

1. Display the phase of the upgrade process. Enter the act-upgrade:action=dbstatus command.

   The phase of the upgrade process is shown in the header of the command output.

2. Re-enter the act-upgrade command that generated this error message, specifying an action that corresponds to the upgrade phase. Refer to the command description in Commands User's Guide for a list of upgrade phases.

Recovery - act-flash

1. Display the GPLs running on the cards installed in the system. Enter the rept-stat-gpl command.

   A plus sign (+) in the column between the RUNNING and APPROVED columns indicates an inactive GPL.

2. If the GPL is inactive, re-enter the act-flash command that generated this error message.

   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).

Recovery - init-flash

1. Display the GPLs running on the cards installed in the system. Enter the rept-stat-gpl command.
   A plus sign (+) in the column between the RUNNING and APPROVED columns indicates an inactive GPL.
2. If the card is not running an inactive GPL, re-enter the init-flash command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).