E2724 Cmd Rej: S13 Feature Must Be Enabled

For the chg-dconn command, the S13/S13' Int for EIR feature must be enabled before changing any parameter of a diameter connection.

For the chg-deiropts command, the S13/S13' Int for EIR feature must be enabled before changing any DEIR configuration.

For the dlt-dconn command, the S13/S13' Int for EIR feature must be enabled before deleting any existing diameter connection.

For the ent-card command, the S13/S13' Int for EIR feature must be enabled before the type=dsm and appl=deirhc parameters can be specified.

For the ent-dconn command, the S13/S13' Int for EIR feature must be enabled before entering any diameter connection.

For the rtrv-dconn command, the S13/S13' Int for EIR feature must be enabled before retrieving any diameter connection entry.

For the rtrv-deiropts command, the S13/S13' Int for EIR feature must be enabled before retrieving Diameter EIR configuration options.

Recovery

1. Enter the rtrv-ctrl-feat command to display the status of the S13/S13' Int for EIR feature.
   If the feature does not appear in the output, then the feature is not enabled.
2. Enable the S13/S13' Int for EIR feature as necessary. Refer to EIR User's Guide for assistance.
3. Re-enter the command that generated this error message.
   If this error message appears again, contact My Oracle Support. See My Oracle Support (MOS).