E2341 Cmd Rej: May not change adjacent point code type

The value specified for the new adjacent point code (APC) must have the same point code type as the current APC of the linkset.

Recovery

1. Display the linkset that generated this error message. Enter the rtrv-ls command.

   ANSI APCs are shown in the APCA field of the output. ITU-I APCs are shown in the APCI field. ITU-N APCs are shown in the APCN field.

2. Display the point codes in the Destination Point Code table. Enter the rtrv-dstn command.
   ANSI destination point codes (DPCs) are shown in the DPCA field; ITU-I DPCs are shown in the DPCI field; ITU-N DPCs are shown in the DPCN field, and 24-bit ITU-N DPCs are shown in the DPCN24 field of the output.
3. Adjust the point code information as necessary. Refer to Database Administration - SS7 User's Guide for assistance.
4. Re-enter the chg-ls command that generated this error message, specifying a DPC shown in the rtrv-dstn output whose point code type matches the point code type of the APC shown in the rtrv-ls output. Refer to the command description in Commands User's Guide and to Database Administration - SS7 User's Guide for assistance.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).