E3017 Cmd Rej: GWS DUP Point Code is required for GWS DUP stop action

For the chg-gws-actset command, the GWS DUP point code (GDPC) must be configured in the STPOPTS table before the GWS DUP stop action can be specified.

For the chg-stpopts command, the GWS DUP point code (GDPC) cannot be set to invalid if the GWS DUP stop action is configured.

Recovery - chg-gws-actset

1. Display the GDPC by entering the rtrv-stpopts command. If the following line is displayed in the output, that GDPC is not configured:

   GDPCA            --------------

2. Configure the GDPC using the chg-stpopts command.
3. Re-enter the chg-gws-actset command.

   Refer to the command descriptions in Commands User's Guide for assistance. Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).

Recovery - chg-stpopts

1. Display the GWS stop actions configured in the EAGLE by entering the rtrv-gws-actset command.
   The GWS stop actions configured are shown in fields act1 through act10.
2. Remove all configured GWS DUP stop actions from all the action sets by using the chg-gws-actset command.
3. Re-enter the chg-stpopts command.
   Refer to the command descriptions in Commands User's Guide for assistance. Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).