0298 - Card Not Using config. SCTP csum Method

The IPLIMx/IPGWx card issues this UAM alarm when the card's active SCTP checksum algorithm does not match the configured SCTP checksum algorithm in the IP OPTIONS table.

Example
RLGHNCXA21W 03-02-07 11:02:30 EST  EAGLE 35.0.0
*  0100.0298  * CARD  1115 DCM   Card not using config. SCTP csum method 

Alarm Level: Minor

Recovery

  1. The SCTP checksum algorithm option is configured via the chg-sg-opts command and is stored in the IP OPTIONS table.
    The update applies to the IP OPTIONS tables on disk and IPLIMx/IPGWx card memory. Note that when the SCTP checksum algorithm is updated, IPLIMx/IPGWx cards may not immediately change to the updated checksum algorithm. Before IPLIMx/IPGWx cards can use the configured SCTP checksum algorithm, one of the following conditions must exist.
    • No SCTP associations exist on the IPLIMx/IPGWx card.
    • All SCTP associations provisioned on the IPLIMx/IPGWx card are open=no.
    • The IPLIMx/IPGWx card is initialized.
  2. In an installed system, use either of two methods to condition the cards to accept the change in checksum algorithms:
    • Card initialization (use the init-card command) or
    • Change card association (chg-assoc:aname=xxx:open=no)

      For details about these commands, refer to the Commands Manual.

  3. Issue the chg-sg-opts:sctp_csum=value command to define the checksum algorithm to be used in all SCTP associations.