TCP Port Assignments

During the Oracle VM Storage Connect Plug-In for Oracle Flash Storage Systems installation, you can change the default server port assignment. The server port permits the Oracle VM Server to communicate with the plug-in.

The ports shown in the following table are used for all communications between the Oracle VM Server and the plug-in, and between the Oracle FS System and the plug-in.

Table 1 Oracle VM Server port communication
Port type	Value	Description
Server	8006	The port on which the Oracle VM Server listens. You can change the server port, if needed, to match the port number specified during the Oracle VM Server installation.
TCP	8083	The port used by the plug-in to communicate over HTTPS with the Oracle FS System Pilot. This port is open by default on the Pilot. It must be open between the server upon which the plug-in is installed and the Pilot IP addresses to avoid firewall issues. For an Oracle FS System, use the following CLI command to verify that the service to open this port is enabled: fscli webcli -list If necessary, use the following CLI command to enable the service: fscli webcli -enable For an Axiom system, use the following CLI command to verify that the service to open this port is enabled: axiom webcli -list If necessary, use the following CLI command to enable the service: axiom webcli -enable Note: If port 8083 is not open, contact Oracle Customer Support (http://www.oracle.com/support).