E3881 Cmd Rej: Group Code and/or Spare Point Code of DPC and SPC must match

If an ITU national destination is provisioned, the ITUDUPPC feature is turned on, and the destination uses an SPC, then the group code of the destination must match the group code of the SPC.

For example, if the ITU national true point code has a group code of ee, then destinations with group codes of ee can be added without using an SPC. Destinations with a group code of ff, however, must use an SPC with a group code of ff.

Note:

Once a feature that is controlled using a feature bit has been turned on, it cannot be turned off.

Recovery

1. Display the status of the ITUDUPPC feature. Enter the rtrv-feat command.
2. Display the SPCs in the SPC table. Enter the rtrv-spc command.
3. Re-enter the ent/chg-dstn command that generated this error message, specifying a valid combination of parameters. Refer to the command description in Commands User's Guide and to Database Administration - SS7 User's Guide for assistance.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).