E2535 Cmd Rej: No match on NI parameter during retrieve

For the gateway screening commands, the value specified for the ni parameter must already exist.

For the rept-meas command, if the ni parameter is specified for origin reports, then measurements data must be available at the time the command is entered.

Recovery - Gateway Screening commands

1. Display the current values for the parameters. Enter the command that generated this error message, specifying only the all=yes parameter.
2. Provision new values as necessary. Refer to the Database Administration - GWS User's Guide for assistance.
3. Re-enter the command that generated this error message, specifying a valid combination of parameters.

   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).

Recovery - rept-meas

1. Determine the existing values for the origni and ni parameters. Refer to the Measurements Reference for assistance.
2. Re-enter the rept-meas command that generated this error message, specifying a valid combination of parameters.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).