E3233 Cmd Rej: System serial number has not been locked

The system serial number must be locked in the database before the specified feature can be enabled.

Note:

Contact My Oracle Support and refer to the command description in Commands User's Guide before using the ent-serial-num command to lock the Serial Number table. If an incorrect serial number is locked in the database, a manual procedure and a system disk are required from Oracle.

Recovery

1. Display the serial number information. Enter the rtrv-serial-num command.
2. If the correct serial number has been entered but not locked, enter the ent-serial-num command with the correct serial number and the lock=yes parameter.
3. If the serial number has not been entered, contact the system administrator and refer to the ent-serial-number command in Commands User's Guide for the procedure and information to enter and lock the correct serial number.
4. Re-enter the enable-ctrl-feat command that generated this error message.

   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).