E2183 Cmd Rej: Capability point code is already being used

The value specified for the new STP capability point code (cpca, cpci, cpcn, cpcn24) cannot be the same as an existing STP capability point code.

Recovery

1. Verify the site point codes and capability point codes in the system.
   Enter the rtrv-sid command. The site point codes are shown in the PCA, PCI, and PCN fields of the output. The capability point codes are shown in the CPCA, CPCI, CPCN, CPCN24 fields of the output.
2. Display the destination point codes in the database.
   Enter the rtrv-dstn command. The ANSI destination point codes are shown in the DPCA, DPCI, DPCN, and DPCN24 fields of the output.
3. Re-enter the chg-sid command that generated this error message, specifying a valid combination of parameters. Refer to the command description in Commands User's Guide and to Database Administration - SS7 User's Guide for assistance.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).