E4440 Cmd Rej: Card running the specified code load.

If all flash GPLs are already running the approved code load, then the flash-card command does not have any effect. If any flash GPL is not approved, then the flash-card command re-flashes only the non-approved GPL(s).

Recovery

1. Display the GPL version that is running on the card. Enter the rept-stat-card:mode=full:loc=<xxx> command for the location of the card of interest.
2. If the current GPL version is already running on the card, then no further action is necessary.
3. If the card is not running the correct GPL version, then re-enter the flash-card command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).